Hamshack Hotline Wiki

• This device is also known as the Linksys SPA-2102
• Your Cisco SPA-2102 must be unlocked.
• This guide does not cover ROUTER functions/options of device.
• See bottom of page for how to factory reset this device.

Step 1 is for a new extension request , where the endpoint has not ever been previously provisioned.

If you have previously provisioned your phone and just need to re-provision it, skip ahead to step #3

NOTE: These instructions are for configuring a SPA-2102 Analog Telephone Adaptor for use on the Hamshack Hotline.

Once you get your phone adapter, simply send us the MAC address from the bottom label and we will create an HTTP profile for it. Send a picture of the MAC address label to the HHOPS help desk by opening a ticket.

HHOPS help desk can be reached at: https://hd.hamshackhotline.com/

• Power off (un-plug) your SPA-2102 device.
• Connect an Ethernet Cable from the Internet (blue) port of the SPA-2102 to your LAN.
• Connect your regular handset phone, to the Line-1 port of the SPA-2102.
• Then power up (plug-in) the SPA-2102.
• Dial * * * *      (four stars) to bring up the device's voice response menu.
• Dial 2 1 0 #      and listen to it speak the LAN IP address to you. Write it down.
• Dial 7 9 3 2 #      then when prompted, press 1 to enable and 1 again to confirm.

Once the profile is created, you can quickly setup your phone or adaptor on HH simply by entering the following URL on your browser:

 http://x.x.x.x/admin/resync?http://apps2.hamshackhotline.com:2443/spacfg-$MA.cfg

(NOTE: x.x.x.x is the local IP address of the phone on your LAN that you wrote down from the above steps)

HHUS Users Provision Note: Please note that you can provision your phone, but the line will not become active until after 4:00am Eastern time, the next day after you receive a response from the HHOPS help desk.

The HHOPS help desk responds to help desk tickets via email usually within 24-48 hours. Please remember to check your spam folder if you don’t receive a response within that time frame.

You are now ready to use Hamshack Hotline!

Dial *97 to access your voicemail box and setup your greetings & preferences!

Step 1: Connect a phone into TEL1 port

Step 2: On the handset dial digits * * * *      (4 Stars)

Step 3: Dial: 7 3 7 3 8 #

Step 4: Press 1 to confirm